It can also be used between two ports that are in two different VDOMs and verify the connectivity at the hardware level.ĭiag traffictest server-intf port2 <- Define a FortiGate interface.ĭiag traffictest client-intf port1 <- Define a FortiGate interface.Ĭonnecting to host 10.109.19.237, port 162 It is used to determine whether transmitted signals return to the sender. Perform loopback testing between two different FortiGate ports:Ī loopback test is a simple method to determine whether the communication of circuits is functioning at a basic interface level.The FortiGate firewall has a built-in iPerf3 client and a limited embedded iPerf3 server.

Publicly available iPerf/iPerf3 Servers.

Run the command (substitute the appropriate value from the table below for in the uninstall command line (include the curly braces).This article describes how to use the diag traffictest command for the following purposes:.

Start a command prompt (Administrator command prompt if Windows Vista or higher).

The second one is to provide the original. The first one is to uninstall using the GUID. There are two options for uninstalling via msiexec. This method requires the uninstall password, unless there is not one configured or it has been disabled (see below).

Run the batch file with administrator privileges.

Copy the batch file to the client computer.

If the agent was installed with an uninstall password, add that information to the batch file.

See About the Symantec DLP Agent Install Files.

Obtain the batch file from the agent install files that were used when installing the agent.

We provide an uninstall_agent.bat / uninstall_agent64.bat with the agent install files.įollow these steps to use this batch file: Windows Agent Uninstall Method 1: Use Uninstall_agent batch file Note: Administrative privileges will be required to perform these uninstall steps.

Alternative solution: Disable the Mac DLP Agent.

Method 2: Msiexec command line uninstall.Method 1: Use Uninstall_agent batch file.

Run-Command 6.01 download the new